home *** CD-ROM | disk | FTP | other *** search
- Subject: Setting DMA on Novell Ethernet NE1000 Cards
- Date: December 29, 1987
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
-
- GENERAL
- INFORMATION: We obtained the following information from Mary at SCS Tech
- Support:
-
- To Set the NE1000 card to function with DMA,
- DMA 1: jumpers 1 & 3 in the DMA Section
- DMA 3: jumpers 2 & 4 in the DMA section
-
- Refer to the NE1000 Installation Supplement to locate the DMA
- block of jumpers; the above positions are from the left (the
- IRQ jumper block). Page A-4. The IRQ block takes 4
- positions, DMA block 4, I/O address 2 positions.
-
- The information was requested by a customer who had bought
- NE1000 cards to use in a Banyan LAN (our advice was to sell
- the customer a Netware OS!).
-