home *** CD-ROM | disk | FTP | other *** search
- Path: sparky!uunet!olivea!spool.mu.edu!uwm.edu!ogicse!news.u.washington.edu!carson.u.washington.edu!whit
- From: whit@carson.u.washington.edu (John Whitmore)
- Newsgroups: sci.electronics
- Subject: Re: Power Amplifiers
- Message-ID: <1k247hINNsof@shelley.u.washington.edu>
- Date: 26 Jan 93 01:30:25 GMT
- References: <1jkrndINNrht@usenet.INS.CWRU.Edu> <15579.2b5e3cf6@ohstpy.mps.ohio-state.edu> <1993Jan25.135100.46744@kuhub.cc.ukans.edu>
- Organization: University of Washington, Seattle
- Lines: 22
- NNTP-Posting-Host: carson.u.washington.edu
-
- In article <1993Jan25.135100.46744@kuhub.cc.ukans.edu> rsl09@kuhub.cc.ukans.edu writes:
-
- > I am interested in a power amplifier that could drive a DC motor/actuator.
- >I am using the actuator in a slow-response feedback loop. The power amplifier
- >should interface an OP-AMP, that produces the error signal, and the
- >actuator that demands up to 3 Amps for input voltages up to 20 volts.
- >Therefore, I need a push-pull 60 W DC power amplifier. I have been able
- >to find couple of power OP-AMPs that seem to to able to do the job. But,
- >they are expensive - price is around $100.
-
- And, power op amps can usually NOT handle an inductive load
- (like a motor). They will burn up (no, internal current limiting
- is NOT a solution here: the problem is reverse-biasing the output
- transistors' emitter junction, and kills the amplifier at LOW current).
-
- If the motor doesn't need to reverse, a PWM switching
- regulator + pass transistor can do a good job. In the general
- case, you might consider buying a computer-controlled stepping
- motor for the task (but that doesn't interface nicely with
- an op amp feedback circuit...).
-
- John Whitmore
-