home *** CD-ROM | disk | FTP | other *** search
- Newsgroups: misc.consumers.house
- Path: sparky!uunet!zaphod.mps.ohio-state.edu!moe.ksu.ksu.edu!crcnis1.unl.edu!wupost!spool.mu.edu!umn.edu!gaia.ucs.orst.edu!news.cs.indiana.edu!noose.ecn.purdue.edu!en.ecn.purdue.edu!ghg
- From: ghg@en.ecn.purdue.edu (George Goble)
- Subject: Re: Need Help From Plumbing Gurus
- Message-ID: <1993Jan2.215159.20170@en.ecn.purdue.edu>
- Organization: Purdue University Engineering Computer Network
- References: <1993Jan2.203935.21414@cbfsb.cb.att.com>
- Distribution: usa
- Date: Sat, 2 Jan 93 21:51:59 GMT
- Lines: 25
-
- In article <1993Jan2.203935.21414@cbfsb.cb.att.com> sbrenner@cbnewsb.cb.att.com (scott.d.brenner) writes:
- >
- >Today, I saw something strange. I checked the pressure gauge
- >a few times throughout the morning, and it was always at about 80
- >pounds. Then, around lunchtime, I saw that the pressure gauge had
- >pegged itself at about 120 PSI. I noticed that the water heater was
- >on at the time (by "on," I mean actively heating water). I shut off
-
- The water company has installed a "backflow preventer". This is
- a one way "check valve", to keep you from feeding water out
- back to their mains.
-
- When your hot water heater heats water, the water must expand, just
- a little bit, but since it has nowhere to expand to, the pressure
- rises violently (hydraulic effect). The usual way to fix this
- is to install an "expansion tank", a 2-3 gal tank, which has
- a rubber diaphram, and it can be connected anywhere in your plumbing,
- even the cold water side. When the water expands, it now has somewhere
- to go and the pressure will not violently rise.
-
- I think there also exists something which goes into a toilet tank,
- which is just a relief valve like the water heater, but set at a lower
- pressure, so when the expansion happens, you get about a quart
- added to the toilet tank.. may be cheaper than an expansion tank.
- --ghg
-