home *** CD-ROM | disk | FTP | other *** search
- Newsgroups: sci.physics
- Path: sparky!uunet!think.com!sdd.hp.com!ux1.cso.uiuc.edu!news.cso.uiuc.edu!ux4.cso.uiuc.edu!cburian
- From: cburian@ux4.cso.uiuc.edu (Christopher J Burian)
- Subject: Re: _Voltage_ ratings of fuses
- References: <1egpleINNie8@crcnis1.unl.edu> <1992Nov19.223618.2711@sfu.ca>
- Message-ID: <By3Ftz.IHK@news.cso.uiuc.edu>
- Sender: usenet@news.cso.uiuc.edu (Net Noise owner)
- Organization: University of Illinois at Urbana
- Date: Sun, 22 Nov 1992 01:22:47 GMT
- Lines: 40
-
- palmer@sfu.ca (Leigh Palmer) writes:
-
- >In article <1egpleINNie8@crcnis1.unl.edu> cbettis@unlinfo.unl.edu (clifford
- >bettis) writes:
- >>
- >>The other day the fuse blew in our microwave oven and in the process
- >>of replacing it, I noticed it had a voltage as well as a current
- >>stamped on it. I'd been aware of this before but never really thought
- >>about it. Why is there a voltage rating for a fuse; is it a matter of
- >>how much resistance the fuse has, or possibly some sort of breakdown
- >>by arcing limitation? If it is a matter of resistance, why not always
- >>use the fuse with a lower voltage rating?
-
- >After the fuse blows there may be a voltage drop across it. That's what one has
- >to worry about.
-
- >I have replaced the fuse in my microwave oven twice. To do so I have to take
- >the whole case off the damn thing - they were too cheap to put on a shielded,
- >socketed fuse. Do you have the same problem? I note that there is an access
- >door to the oven light bulbs.
-
- >I'm sure lots of perfectly serviceable microwave ovens get discarded when thay
- >blow fuses because of this "feature". It is probably due to some unreasonable
- >radiation requirement for these beasts.
-
- >Leigh
-
- The voltage rating of a fuse is an arcing limitation. As one examines
- fuses of higher ratings they are longer, and filled with sand that melts
- to provide an insulating barrier.
-
- Microwave oven fuses are *not* easily replaced for safety reasons. The
- manufacturers want qualified service personnel to replace the fuses only
- after determining the cause of the failure. Manufacturers are also very
- concerned about the integrity of the shielding. The fuse often blows
- because the door safety switch has failed. It more often blows due to
- age, but they don't want to take chances with lawsuits.
-
- Chris Burian---
-
-