10001 Unable to open capture driver.\n\nThe driver is either not installed or is in use by another application.
10002 Can't connect to capture driver.
10003 Can't start previewing.
10004 Can't set previewing rate.
10005 CAPFILE.AVI
10006 Stop Motion
10007 Warning: Some frames were dropped or none were captured.The video source may not be connected, or your capture hardware may have an IRQ or other conflict.Please check your setup and try again.
10008 The capture process was halted before any frames were captured.
10009 Cannot save the captured bitmap.The destination disk may be full,or the video source is inactive.
10010 Error during capture:Error writing file.
10011 Error during capture:Driver error.
10012 Error during capture:Error capturing audio. Make sure your audio device is properly configured.
10013 Error during capture:Out of memory.
10014 Error during capture.
10015 Error during capture:Error writing to disk (disk full?).
10016 Unable to create capture file.The disk is full or write-protected.
10017 Captured XX.XXX sec. XXX frames (XX dropped) (XX.XX fps)
10018 Capturing palette...
10019 Save Palette
10020 Load Palette
10021 Microsoft Palette#*.pal##
10022 pal
10023 Capture
10024 Start
10025 Done
10026 Step
10027 Stop
10028 Unable to capture image.\n\nThe video format must be set to 24-bit or 8-bit RGB.\n\nPlease choose a compatible format using the Capture Options dialog.
10029 The Still Image Capture window cannot be opened while the Movie Recorder window is open.