10001	Unable to open capture driver.\n\nThe driver is either not installed or is in use by another application.
10002	Can't connect to capture driver.
10003	Can't start previewing.
10004	Can't set previewing rate.
10005	CAPFILE.AVI
10006	Stop Motion
10007	Warning: Some frames were dropped or none were captured.
The video source may not be connected, or your capture hardware may have an IRQ or other conflict.
Please check your setup and try again.
10008	The capture process was halted before any frames were captured.
10009	Cannot save the captured bitmap.

The destination disk may be full,
or the video source is inactive.
10010	Error during capture:

Error writing file.
10011	Error during capture:

Driver error.
10012	Error during capture:

Error capturing audio. Make sure your audio device is properly configured.
10013	Error during capture:

Out of memory.
10014	Error during capture.
10015	Error during capture:

Error writing to disk (disk full?).
10016	Unable to create capture file.

The disk is full or write-protected.
10017	Captured XX.XXX sec. XXX frames (XX dropped) (XX.XX fps)
10018	Capturing palette...
10019	Save Palette
10020	Load Palette
10021	Microsoft Palette#*.pal##
10022	pal
10023	Capture
10024	Start
10025	Done
10026	Step
10027	Stop
10028	Unable to capture image.\n\nThe video format must be set to 24-bit or 8-bit RGB.\n\nPlease choose a compatible format using the Capture Options dialog.
10029	The Still Image Capture window cannot be opened while the Movie Recorder window is open.
10030	Manual capture in progress.
10031	Time lapse capture in progress.
10032	Ready for manual capture
10033	Ready for time lapse capture
10034	Ready for still capture
10035	Capture halted. Disk full.