Setting Only One Mark
| Mark IN button | | Mark OUT button |
| Record button |
|
|
To set only one mark and enter the other mark on-the-fly, do one of
the following:
|
|
Mark an IN point, and click the Capture button to begin capturing.
Then, click the Capture button again to stop capturing on-the-fly and
mark an OUT point.
|
This method is useful if you do not need a precise OUT point. You
save time because you do not have to shuttle to locate the OUT point
before capturing.
|
|
|
Set an OUT point only, and then move to a position on the tape that is a
few seconds before where you want to start capturing. Play the tape,
and then immediately click the Capture button to begin capturing on-
the-fly. When the tape reaches the clip's OUT point, capturing stops.
|
This method is useful if you do not need a precise IN point but do need
to stop at a precise OUT point, for example, just before a timecode
break.
