Included on the setup disk for your zip drive is a ASPI driver for the parallael prot zip.
I believe it is acalled ASPIPPA3.SYS and can be loaded in the config.sys
The guest.exe driver that you use to set up your zip drive actually uses this driver if you are not scsi. This driver will also work with the Iomega Parallel port Zip interface. Question? Can the IOMEGA Mac Zip Tools run under executor?
----------
From: Clifford T. Matthews[SMTP:ctm@ardi.com]
Sent: Thursday, November 09, 1995 11:59 AM
To: Anton Callaway
Cc: executor@nacm.com
Subject: Re: Zip100 parallel and E/D
>>>>> "Anton" == Anton Callaway <asc3@cornell.edu> writes:
Anton> E/D 1.99o reads/writes my DOS-formatted Zip discs with my
Anton> parallel port drive, but gives me a blank (no files
Anton> showing) box when I double-click on the Zip drive if it has
Anton> a Mac disk in it. Though I know that the Mac Guest
Anton> software only deals with SCSI Zips, I tried to run the Mac
Anton> Guest with E/D anyhow and got an error message suggesting
Anton> that I reboot without extensions. Does Iomega need to come
Anton> out with a Guest for Executor to read Mac discs in a
Anton> parallel drive or is there a not-to-difficult way to get
Anton> Executor to read Mac Zip discs?
It might be possible for someone to kludge an ASPI driver for the
parallel drive, and then Executor would work on it, but I don't think
anyone has done such a thing, nor do I think anyone is planning on it.
