home *** CD-ROM | disk | FTP | other *** search
- -------------------------------------------------------------------------
-
- Filename....: FDTN-003; FrontDoor Technical Note #003
- Rev.........: 002
- Dated.......: 08-Jan-1995
-
- Subject.....: Use of FrontDoor 2.12, FrontDoor 2.20c.mL and above
- with USRobotics Courier and Sportster modems
-
- Author......: Edward Hobson
- 2:443/59.24@fidonet
-
- -------------------------------------------------------------------------
-
- FDSETUP, Modem menu:
-
- +----------------------------------------- Command strings +
- | |
- | Escape code +++ |
- | Return on-line ~ATO| |
- | Onhook ATH0| |
- | Offhook ~ATM0H1| | * Note!
- | Dial ATDT | ** Note!
- | \-Prefix |
- | \-Suffix | |
- | Delay 3 |
- | Init-1 AT&F&A3&B1&H1&R2&K2&M4E0H0S15=8| |
- | Init-2 ATS19=4S28=20S34=8| |
- | Init-3 | |
- | Down ~ATM0H1| | * Note!
- | Attention AT| |
- | |
- +----------------------------------------------------------+
-
- * In some countries/states it is illegal to take the line off-hook for
- long periods of time. In others, you are billed from the second the
- line goes off-hook. If you previously configured 'Lower DTR when
- busy' to 'Yes' then the 'Offhook' string will never be sent.
- However, the 'Down' string is sent regardless of this setting. If
- you want to ensure that the line is never busied out by the modem
- going 'off-hook' then blank out both of these strings.
-
- ** If your telephone exchange cannot support MFT tone dialling, change
- the 'Dial' string to read 'ATDP' (do not include quotation marks).
-
- +----------------------------------------- Answer control +
- | |
- | Manual answer Yes |
- | Force answer ATB0M1A| |
- | Answer delay 1 |
- | Enable LDFRS No |
- | |
- +---------------------------------------------------------+
-
- FDSETUP, Manager menu, Modem sub-menu:
-
- These options allow you to configure FrontDoor to send specific
- commands to the modem, if it matches a particular speed, nodelist
- flag, or node number with the system being called.
-
- In the case of USRobotics Courier Dual Standard modems (those
- supporting HST as well as regular ITU high speed protocols) it is
- important to choose the highest supported protocol when dialling out.
- Insert each of the following lines in the correct order. If your
- Courier modem does not support HST as well as ITU high speed protocols
- then omit this section.
-
- HST ATB1|
- V32 ATB0|
- H14 ATB1|
- V32B ATB0|
- H16 ATB1|
-
- End of document
- ===============
-