Copyright (C) 1992 by Digital Innovations. All rights reserved.
To use this utility, the DOS files MODE.COM and DEBUG.COM must be
present on the remote system, and XPORT.EXE must be present on this
system. You must also have a null-modem cable connected between the
two systems, and know which serial port the cable is connected to on
the remote system (COM1 or COM2).
Press any key to continue or ESC to quit....
$Now enter the following on the remote system:
MODE COMx:96,N,8,2 <ENTER>
then,
CTTY COMx <ENTER>
(Where the 'x' in COMx is replaced by the port number)
then,
Press any key....
$Connection OK - XPORT.EXE will be copied into remote $
$
Is this OK (Y/N)? $I'm not getting a response from the remote system.
Check cable and serial port number, and press ENTER to continue.
NOTE: If the cable and port numbers are OK, and you are using a
cable that has DTR connected to DSR on the target system end of the
cable, try copying a file to COMx before issuing the CTTY command,
as described in XCLONE.DOC.
Press ESC to quit.
$Transferring XPORT.EXE, please stand by...
$I could not find XPORT.EXE - change the drive and/or directory
to where XPORT.EXE is, or copy it to the current location and
try again.
$Error encountered reading XPORT.EXE, aborting.
$Change the remote system to the drive and subdirectory that you want
XPORT.EXE to be copied into. (But be sure that the PATH is set so that DEBUG
can be executed from the default drive and subdirectory.)
Hit ESC to abort or any other key to continue.
$Transfer procedure complete.
Thanks for trying out XPORT, the Digital Innovations File Transporter;
by far, the very best value in file transfer utilities available!
$Unexpected response from remote system, aborting.
$Checking connection....$Data mismatch error encountered during readback, aborting.
$XPORT.EXE DEBUG E 100 BF 00 02 BA F8 03 80 3E 85 00 31 74 0A BA F8 02 E 110 80 3E 85 00 32 75 14 89 16 80 00 83 C2 05 EC A8 E 120 01 74 FB 83 EA 05 EC AA EE E2 F0 E2 FE CD 20 G=100 RCX N XPORT W 200 Q REN XPORT XPORT.EXE DIR XPORT.EXE>CON CTTY CON @ Invoking DEBUG - $DEBUG running
$Sending loader.
$Starting loader.
$Sending file data.
$Saving XPORT.EXE to disk...
$Remote echo error encountered.
$Error encountered during file transfer, aborting.
