home *** CD-ROM | disk | FTP | other *** search
-
- ; *** Listing 1 ***
- ;
- ; Program to illustrate searching through a buffer of a specified
- ; length until either a specified byte or a zero byte is encountered.
- ; A standard loop terminated with LOOP is used.
-
- .model small
- .stack 100h
- .data
- ; Sample string to search through.
- SampleString label byte
- db 'This is a sample string of a long enough length '
- db 'so that raw searching speed can outweigh any '
- db 'extra set-up time that may be required.',0
- SAMPLE_STRING_LENGTH equ $-SampleString
-
- ; User prompt.
- Prompt db 'Enter character to search for:$'
-
- ; Result status messages.
- ByteFoundMsg db 0dh,0ah
- db 'Specified byte found.',0dh,0ah,'$'
- ZeroByteFoundMsg db 0dh,0ah
- db 'Zero byte encountered.',0dh,0ah,'$'
- NoByteFoundMsg db 0dh,0ah
- db 'Buffer exhausted with no match.',0dh,0ah,'$'
-
- .code
- Start proc near
- mov ax,@data ;point to standard data segment
- mov ds,ax
-
- mov dx,offset Prompt
- mov ah,9 ;DOS print string function
- int 21h ;prompt the user
-
- mov ah,1 ;DOS get key function
- int 21h ;get the key to search for
-
- mov ah,al ;put character to search for in AH
- mov cx,SAMPLE_STRING_LENGTH ;# of bytes to search
- mov si,offset SampleString ;point to buffer to search
- call SearchMaxLength ;search the buffer
- mov dx,offset ByteFoundMsg ;assume we found the byte
- jc PrintStatus ;we did find the byte
- ;we didn't find the byte, figure out
- ; whether we found a zero byte or
- ; ran out of buffer
- mov dx,offset NoByteFoundMsg
- ;assume we didn't find a zero byte
- jcxz PrintStatus ;we didn't find a zero byte
- mov dx,offset ZeroBytefoundMsg ;we found a zero byte
- PrintStatus:
- mov ah,9 ;DOS print string function
- int 21h ;report status
-
- mov ah,4ch ;return to DOS
- int 21h
- Start endp
-
- ; Function to search a buffer of a specified length until either a
- ; specified byte or a zero byte is encountered.
- ;
- ; Input:
- ; AH = character to search for
- ; CX = maximum length to be searched (must be > 0)
- ; DS:SI = pointer to buffer to be searched
- ;
- ; Output:
- ; CX = 0 if and only if we ran out of bytes without finding
- ; either the desired byte or a zero byte
- ; DS:SI = pointer to searched-for byte if found, otherwise byte
- ; after zero byte if found, otherwise byte after last
- ; byte checked if neither searched-for byte nor zero
- ; byte is found
- ; Carry Flag = set if searched-for byte found, reset otherwise
-
- SearchMaxLength proc near
- cld
- SearchMaxLengthLoop:
- lodsb ;get the next byte
- cmp al,ah ;is this the byte we want?
- jz ByteFound ;yes, we're done with success
- and al,al ;is this the terminating 0 byte?
- jz ByteNotFound ;yes, we're done with failure
- loop SearchMaxLengthLoop ;it's neither, so check the next
- ; byte, if any
- ByteNotFound:
- clc ;return "not found" status
- ret
- ByteFound:
- dec si ;point back to the location at which
- ; we found the searched-for byte
- stc ;return "found" status
- ret
- SearchMaxLength endp
- end Start
-