home *** CD-ROM | disk | FTP | other *** search
/ NetNews Usenet Archive 1992 #31 / NN_1992_31.iso / spool / misc / consumer / house / 16238 < prev    next >
Encoding:
Internet Message Format  |  1993-01-03  |  2.0 KB

  1. Path: sparky!uunet!mcsun!uknet!doc.ic.ac.uk!agate!spool.mu.edu!wupost!zaphod.mps.ohio-state.edu!pacific.mps.ohio-state.edu!linac!att!att!ulysses!ulysses!smb
  2. From: smb@research.att.com (Steven Bellovin)
  3. Newsgroups: misc.consumers.house
  4. Subject: Re: Honeywell Electronic Thermostat
  5. Message-ID: <1993Jan3.180924.21149@ulysses.att.com>
  6. Date: 3 Jan 93 18:09:24 GMT
  7. References: <1i4t5nINNq4i@usenet.INS.CWRU.Edu> <C0ACqo.2HM@boi.hp.com>
  8. Organization: AT&T Bell Laboratories
  9. Lines: 26
  10.  
  11. In article <C0ACqo.2HM@boi.hp.com>, dougl@mail.boi.hp.com (Doug Leno) writes:
  12. > Chronotherm III is the  correct name, referring to a family of 'stats with
  13. > Adaptive Intelligent Recovery (AIR).  There are three models and many 
  14. > variations within each model.  These stats are also referred to as the
  15. > "8600" family, because the model numbers are 8600, 8602, and 8621.
  16. > :  b) What did you pay for it, and where?
  17. > They are available only through authorized Heating/AC contractors, hence the
  18. > "Trade Line" designation.  For single stage equipment, expect to pay
  19. > (over-the-counter) around $150 for the 8600 or as high as $200 for an 8621.
  20. > ... However, you should be able to find one [contractor]
  21. > willingto sell the stat to you over-the-counter (no installation).
  22.  
  23. I, and several other people I know, have purchased them from plumbing
  24. and heating supply stores, with no trouble, winks, etc.  I think I paid
  25. ~$25 less than you indicate, 1.5 years ago.
  26.  
  27. The kicker is that the installation instructions are not ``consumer-
  28. friendly''.  That is, you're not going to find handy, step-by-step
  29. instructions on how to figure out which wire goes where.  You're going
  30. to have to rely on some circuit diagrams, and maybe some common sense.
  31. My brother-not-quite-(yet?)-in-law ran into trouble installing one;
  32. however, Honeywell's customer service line was very helpful, and talked
  33. him through the proper setup.  In general, the simpler your situation
  34. (i.e., heat only, no AC, no zone relays), the easier time you'll have.
  35.