home *** CD-ROM | disk | FTP | other *** search
- Path: sparky!uunet!usc!zaphod.mps.ohio-state.edu!sol.ctr.columbia.edu!emory!ogicse!flop.ENGR.ORST.EDU!leela!lairdt
- From: lairdt@leela.cs.orst.edu (Tom Laird)
- Newsgroups: comp.os.linux
- Subject: Re: ANNOUNCE: Linux 0.98 pl5
- Message-ID: <1992Nov18.043834.14590@leela.cs.orst.edu>
- Date: 18 Nov 92 04:38:34 GMT
- Article-I.D.: leela.1992Nov18.043834.14590
- References: <1992Nov15.220138.5434@klaava.Helsinki.FI> <jpo.721994610@hrz.tu-chemnitz.de> <1992Nov17.231051.19258@sfu.ca> <1992Nov18.002608.12410@leela.cs.orst.edu>
- Organization: Computer Science Outreach Services - Oregon State University
- Lines: 14
-
- lairdt@leela.cs.orst.edu (Tom Laird) writes:
-
- >I just finished pulling SLS 0.98p5 off of tsx-11 two hours ago.
-
- I found the problem... the drive which wrote the disks was out of
- alignment, and when redone on another system SLS installs fine.
-
- HOWEVER.... I installed everything (option 3) and when I boot the system up
- it says it can't find WD8013 (which is fine since I don't have one),
- looks for SCSI drive (none), and then after checking the partitions
- it locks up, never to come back again. Too bad I had to blow away 0.98p1
- to install this version.
-
- Any ideas?
-