# The contents of this file are subject to the Mozilla Public License Version
# 1.1 (the "License"); you may not use this file except in compliance with
# the License. You may obtain a copy of the License at
# http://www.mozilla.org/MPL/
#
# Software distributed under the License is distributed on an "AS IS" basis,
# WITHOUT WARRANTY OF ANY KIND, either express or implied. See the License
# for the specific language governing rights and limitations under the
# License.
#
# The Original Code is Mozilla Progress Dialog.
#
# The Initial Developer of the Original Code is
# Netscape Communications Corp.
# Portions created by the Initial Developer are Copyright (C) 2002
# the Initial Developer. All Rights Reserved.
#
# Contributor(s):
# Bill Law <law@netscape.com>
#
# Alternatively, the contents of this file may be used under the terms of
# either the GNU General Public License Version 2 or later (the "GPL"), or
# the GNU Lesser General Public License Version 2.1 or later (the "LGPL"),
# in which case the provisions of the GPL or the LGPL are applicable instead
# of those above. If you wish to allow use of your version of this file only
# under the terms of either the GPL or the LGPL, and not to allow others to
# use your version of this file under the terms of the MPL, indicate your
# decision by deleting the provisions above and replace them with the notice
# and other provisions required by the GPL or the LGPL. If you do not delete
# the provisions above, a recipient may use your version of this file under
# the terms of any one of the MPL, the GPL or the LGPL.
#
# ***** END LICENSE BLOCK *****
readError=%S could not be saved, because the source file could not be read.\n\nTry again later, or contact the server administrator.
writeError=%S could not be saved, because an unknown error occurred.\n\nSorry about that. Try saving to a different location.
launchError=%S could not be opened, because an unknown error occurred.\n\nSorry about that. Try saving to disk first and then opening the file.
diskFull=There is not enough room on the disk to save %S.\n\nRemove unnecessary files from the disk and try again, or try saving in a different location.
readOnly=%S could not be saved, because the disk, folder, or file is write-protected.\n\nWrite-enable the disk and try again, or try saving in a different location.
accessError=%S could not be saved, because you cannot change the contents of that folder.\n\nChange the folder properties and try again, or try saving in a different location.