2 Please make sure if the display device(s) is(are) ready.\nIf you can not see anything after the switch, please do not\ntouch the keyboard. The display will automatically come\nback onto the current device in about 15 seconds.
3 Windows will now adjust your display settings. This could take\na few seconds, during which your screen might flicker.
4 LCD+CRT (Simultaneous)
5 LCD+TV (Simultaneous)
6 LCD+CRT (Dual Display)
7 LCD+TV (Dual Display)
8 TV Standard:
9 Monitor Adjustment
10 Display Devices
12 Desktop
13 Can not do Expansion/Center at following conditions:\n 1. Dual Display Mode.\n 2. True Color Mode.\n 3. 720x480 Mode.
14 Please switch to TV device using Display Device Page. Otherwise, you could not set TV features on the TV page.
15 Trident Digital TV Utility
16 Warning Message
17 Can not check "Enable Different Refresh Rate" button due to your current color palette is True Color (24bit).
18 Trident Utility Help
19 Trident TV Utility
20 You must restart your computer before the new settings will take effect.\n\nDo you want to restart your computer now?
21 OK
22 Cancel
100 Display Device
105 PAL
106 NTSC
107 Enable Different Refresh Rate
108 Video Output on LCD
109 Multi-Monitor Devices:
200 Flat Panel
201 Display Feature:
202 Display Stretch
300 Television
400 Color
401 Reload a Bitmap ...
402 Gamma Adjustment:
403 Link
404 Red
405 Green
406 Blue
407 Gamma Correction does not support under 256 color modes.
500 Video
501 Video Color Adjustment
502 Brightness
503 Contrast
504 Hue
505 Saturation
506 &Enable Video Taskbar Icon
507 &Save
508 &Load
509 &Reset
510 &Close
511 &Exit
512 Trident Video Color Adjustment
600 Memory
601 This setting allows you to configure the amount of system memory used by the video controller. Setting to a higher value may decrease system performance. Setting to a lower value will reduce available video resolutions and color depths.