home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Chip 1997 April (Special)
/
Chip-Special_1997-04_cd.bin
/
trident
/
ua64-dos
/
ua64-dos.exe
/
NT35
/
README
< prev
next >
Wrap
Text File
|
1996-02-14
|
3KB
|
89 lines
***********************************************************************
WINDOWS NT DRIVER SETUP INFORMATION
for
Trident Users
***********************************************************************
Windows NT Device Drivers Version 2.02 Feb 14, 1995
***********************************************************************
Contents
1.0 Introduction
2.0 Supported Resolutions
3.0 Installation Notes for Windows NT Version 3.5
*****************************
1.0 Introduction
This Accelerate Driver runs on the following products:
Trident 93XX/9440/9470/96XX, VESA or PCI local bus adapter
The Graphics Device Drivers supplied here are for the Microsoft
Windows NT 3.5 operating system English version.
*****************************
2.0 Supported Resolutions.
256 colors 65000 colors 16.7 million
Resolutions 8 bpp 16 bpp 24 bpp
640 x 480 1/2/4MB 1/2/4MB 1/2/4MB
800 x 600 1/2/4MB 1/2/4MB 2/4MB
1024 x 768 1/2/4MB 1/2/4MB 4MB
1280 x 1024 2/4MB 4MB N/A
1600 x 1200 (1) 4MB (2) NEW N/A
1/2/4MB - Supported on 1, 2 or 4 Megabyte trident products
NEW - New modes, supported 9682/9685/9385 (4MB).
N/A - Not Supported
(1) - This mode is supported on 2MB board, but 4MB is required for acceleration.
(2) - Not Accelerated.
****************************
3.0 Installation Notes for Windows NT
This driver package containing:
- TGIUL35.SYS (Trident general linear addressing graphics miniport driver)
- TGIUL35.DLL (Trident general linear addressing accelerated graphics display driver)
- FRAMEBUF.DLL (Microsoft general linear addressing graphics display driver)
- VGA.DLL (Microsoft standard VGA display driver)
- OEMSETUP.INF (setup files used by Windows NT Setup program)
- README This README file for Windows NT Version 3.5
Windows NT drivers are included on Disk #2 of this package. They are
located in the \NT35 sub-directory.
Procedure:
1. Run the Windows NT display Setup program located in the Control Panel, Main
group.
2. Select "Change Display Type..." button from the Display Settings options.
3. Select "Change..." button from the Display Type options.
4. Select "Other..." button from the Select Device options.
5. Windows NT will prompt you for the correct path. Enter A:\NT35 if disk 2
is loaded in drive A:.
6. Select "Trident 93xx/9440/9470/96xx Linear Accelerated"
7. Restart Windows NT.
8. Windows NT will start up with default 640x480x256 mode. Select your disired
display setting from the Display Setting.
Note: After changing to Trident driver, the Display setting only allows selecting
valid settings depends on your card.