The Flow Control settings in the driver are incorrect. The driver should be set for RTS/CTS mode, but it is not. Your driver may not be Windows Compatible. Modem may fail the following diagnostic tests.»Modem Doctor Warning
The Carrier Detect Line from modem to driver is active. This needs to be reset with the command AT&C1. Modem Doctor will do this and continue testing.╓Modem Doctor Warning
The CTS handshake line between modem and drive is inactive. Either you have a bad cable or your modem is off.Modem Doctor will continue testing. If there are errors, run driver diagnostics.áModem Doctor Warning
You pressed the abort key during testing. Test results may be incorrect. To properly test, you need to wait until testing is completed.ΩFIXED LINK ADVISORY
Your modem's DTE rate between computer and modem is not locked. I had to lower the baud rate to match the link rate. For high-speed modems, the DTE rate must be locked. Check your modem manual for instructions.úModem Doctor Warning
This command is available only in the Registered Version of the program. Select INFO and Order Form to find out how to register your copy.uModem Doctor Warning
You have not selected a port for testing. Please return to the setup menu and select a port.îModem Doctor Warning
No Fax Capabilities were detected during testing. You need at least a Class 1 Faxmodem in order to run these tests.°RTS/CTS Handshaking
Handshaking instructs your modem when and when not to send characters to your program. Proper operation is necessary for high-speed modems. Modem Doctor will use your current settings or send the proper commands for this test.∙XON/XOFF Handshaking
Handshaking instructs your modem when and when not to send characters to your program. Proper operation is necessary for high-speed modems. Modem Doctor will use your current settings or send the proper commands for this test.