RULED allows you to create a point mesh that approximates
the surface formed by simultaneously moving a line
(generator) along two director curves.

Create the mesh by choosing from the following options:

NUMSEGS - to divide the selected curves into a specific
          number of equal-length segments.

ARCLNTH - to divide the selected curves into segments of a
          specific length, with the last segment being of 
          length equal to, or less than, the specified 
          length.

A temporary mesh is displayed.

Indicate whether or not the curves connected correctly by
choosing from the following options:

NO  - to indicate that the curves are not connected
      correctly.

YES - to indicate that the curves are connected correctly.


Indicate whether or not to create lines in the
cross-direction by choosing from the following options:

NO  - to indicate that you do not want to create lines in
      the cross-direction.

YES - to indicate that you want to create lines in the
      cross-direction.


The NUMSEGS/ARCLNTH menu is displayed again.

Indicate whether or not you want to group the entities.
Choose NO to continue without grouping. Choose YES to
create a group, and enter a group name.

The mesh is created.
