Use your existing Modem Configuration when using the TPG 56K Digital Modem Service. In order to follow the instructions below please ensure that the modem is installed.

Step 1: Setup Instructions

1. Open the My Computer icon
2. Click on the Dial-Up Networking icon, this will prompt you to install The Dialup Networking software. (You may need your NT CD for this).
3. When this installs you may be prompted to install a modem if you haven't already installed one, but if you have one installed then you will need to select it from the list provided.
4. Click on Config and change it to Dial out and Receive calls
5. Click OK and then Yes to reboot the system
6. Go back into Dial-Up Networking and Click on Yes to Add Entry, call it TPG Internet, select calling the internet and then fill in the Phone Number for your location
7. Click Next, and then Finish
8. Click More, then Edit Entry and Modem Properties, and then Server, in here only TCP/IP should be selected in the Network Protocols. And both the Enable Software Compression and Enable PPP LCP Extensions should be selected
9. Now click on TCP/IP Settings, in here you should have Server Assigned IP Address selected, and Server, Assigned, Name Server Address. Make sure that the Use IP Header Compression and the Use Default Gateway On Remote Network are both selected and then click OK
10. Click on Security tab, and ensure that Accept any Authentication including clear text is selected.
11. Click on Dial, fill in your Username and Password, then click OK
12. To dial double click your TPG Internet connection, the system will dial automatically, verify your Username and Password, and connect you to TPG 56K Digital Modem Service