Set up your Microsoft Cordless Wheel Mouse

Setting up your Microsoft Cordless Wheel Mouse includes connecting the receiver, installing batteries into the mouse, and installing the IntelliPoint software.

• When using a PS/2 port, always turn off the computer before you connect or disconnect your device.
• Before boarding any aircraft, remove the batteries from the Microsoft Cordless Wheel Mouse. The Microsoft Cordless Wheel Mouse can emit radio frequency (RF) energy, much like an AM/FM radio, whenever batteries are installed, even if the mouse is turned off.

To connect your device

1. Turn off your computer.
2. Locate the round 6-pin (PS/2) mouse port on the back of your computer.
3. Plug the round 6-pin (PS/2) mouse-port connector, attached to the receiver, into the mouse port.

To install batteries

1. Turn the mouse upside down, and remove the door to the battery compartment.
2. Insert the batteries making sure that you properly orient them for polarity, pointing the positive (+) end towards the "+," and the negative (–) end towards "–"
3. Close the battery compartment cover.

Notes

• See Important Radio Interference and Battery Information for Cordless Wheel Mouse for additional information on proper handling and disposal of batteries.
• If you use more than one Microsoft Cordless Wheel Mouse, set the channel button on each device to a different channel to prevent any interference.

To install the IntelliPoint software

1. Turn on your computer.
2. Insert the Microsoft IntelliPoint Setup compact disc into your CD-ROM drive, and then follow the Setup Wizard instructions on your screen. If the Setup Wizard does not appear, complete steps 3–4.
3. Click the Start button, and then click Run.
4. Type <drive>:setup. For example, if your CD-ROM drive is drive E, type e:setup.
5. Follow the Setup Wizard instructions on your screen.