How to configure SpeedFan.

I have got an ABIT BP6. Its SMBus is supported by SpeedFan and it has got a WINBOND W83782D hardware monitoring chip. This W83782D, like several others from Winbond, shows two additional sensors that appear as two LM75. On my motherboard, the W83782D is both accessible through ISA and SMBus. In my configuration IÆve chosen to access it only through SMBus even though this is not the most relialable setting. ISA is, in fact, more stable, but IÆve chosen this setup for debugging purposes.

So, letÆs start.

This is SpeedFan right after the very first run.

Those flames are not actually a problem. They are due to the fact that SpeedFan has been initially configured (by me) to expect lower values. Temperatures have been sorted trying to put at the top those that make more sense.

Let's got to the CONFIGURATION dialog.