Change Offset
Purpose: You can skip unwanted file information (such as header) and proceed to the main file, while maintaining a zero start (absolute position) at the beginning of the file and another zero start (relative position) at the new offset position.
Desired offset: enter a hex amount of bytes within the bounds
specified above the box field which will be from now on the starting point
of the file for Hackman. This could be very helpful in order to skip header
information.
Pressing Ok will apply the changes, Cancel will ignore
any changes.
Sliding Monitor supports offset changes. Moving your cursor on the cursor position layer, you can see the Relative Position (where 0 is the beginning of the offset that you've set) and the Absolute Position (where your offset changes are ignored).