2	Please make sure if the display device(s) is(are) ready.\nIf you can not see anything after the switch, please do not\ntouch the keyboard. The display will automatically come\nback onto the current device in about 15 seconds.
3	Windows will now adjust your display settings. This could take\na few seconds, during which your screen might flicker.
4	LCD+CRT (Simultaneous)
5	LCD+TV   (Simultaneous)
6	LCD+CRT (Dual Display)
7	LCD+TV   (Dual Display)
8	TV Standard:
9	Monitor Adjustment
10	Display Devices
12	Desktop
13	Can not do Expansion/Center at following conditions:\n	1. Dual Display Mode.\n	2. True Color Mode.\n	3. 720x480 Mode.
14	Please switch to TV device using Display Device Page. Otherwise, you could not set TV features on the TV page.
15	Trident Digital TV Utility
16	Warning Message
17	Can not check "Enable Different Refresh Rate" button due to your current color palette is True Color (24bit).
18	Trident Utility Help
19	Trident TV Utility
20	You must restart your computer before the new settings will take effect.\n\nDo you want to restart your computer now?
21	OK
22	Cancel
100	Display Device
105	PAL
106	NTSC
107	Enable Different Refresh Rate
108	Video Output on LCD
109	Multi-Monitor Devices:
200	Flat Panel
201	Display Feature:
202	Display Stretch
300	Television
400	Color
401	Reload a Bitmap ...
402	Gamma Adjustment:
403	Link
404	Red
405	Green
406	Blue
407	Gamma Correction does not support under 256 color modes.
500	Video
501	Video Color Adjustment
502	Brightness
503	Contrast
504	Hue
505	Saturation
506	&Enable Video Taskbar Icon
507	&Save
508	&Load
509	&Reset
510	&Close
511	&Exit
512	Trident Video Color Adjustment
600	Memory
601	This setting allows you to configure the amount of system memory used by the video controller. Setting to a higher value may decrease system performance. Setting to a lower value will reduce available video resolutions and color depths.
602	Video Memory Configuration:
603	MB (Megabyte)