CD-Recorder Manufacturers
Note: This information is provided without any warranty and
may not be complete. All names may be trademarks or registered trademarks of
their respective owners. If
your CD-Recorder is not listed, you can simply try. If your writer is listed,
please check for required firmware.
This list assumes CloneCD Version 3.x and CCDDriver.dll
Version 3.0.0.11
Back to Hardware Requirements
Firmware:
- If nothing is specified, any firmware version will work. However, the
newest firmware version available is recommended.
- Rev. >= X.X : Firmware version X.X or better is required
- Rev. = X.X : The exact Firmware version X.X is required. Any other version
WILL NOT WORK.
Best Write Mode:
- RAW-DAO 96 = 2352 bytes RAW Data + 96 Bytes
P-W Subchannel Data. This is the best mode for CloneCD. It allows writing of
all subchannel information, including Digital Signatures, CD-Text, ISRC,
Catalog Numbers, CD+G, CD+Midi, Gaps, Indices and Crazy TOCs.
- RAW-DAO 16 = 2352 bytes RAW Data + 16 Bytes
P-Q Subchannel Data. This is the second best mode for CloneCD. It allows
writing of most subchannel information, including most Digital Signatures, ISRC,
Catalog Numbers, Gaps, Indices and Crazy TOCs.
- RAW-SAO = 2352 bytes RAW Data. This is the
third best mode for CloneCD. Feature support is drive dependant. ISRC,
Catalog Numbers and Indices can be written. Usually CD-Text, CD+G and
CD+MIDI can be written as well. Crazy TOCs and Digital Signatures can't be
written in this mode.
- SAO = 2352 bytes error corrected Data. This
is the worst mode for CloneCD. Writing of ISRC, Catalog Numbers, Indices and
usually CD-Text is supported.
- - = Writing to this drive is not supported. CloneCD will not recognize the
drive as a CD-Recorder.
Buffer under run Technology:
= Drive offers a buffer under run
technology like BurnProof or JustLink. This option can be
controlled by the user.
= Drive offers Seamless
Link buffer under run
technology. Seamless Link is always
enabled and can not be switched off.
= Drive offers a buffer
under run technology, but the current CloneCD version does not support this
feature yet. It is very likely, that this feature will be supported in the
future.
= Drive offers a buffer under run
technology like BurnProof or JustLink, but this option does
not work with CloneCD RAW writing and MUST be turned off!- - = Drive does not offer any buffer under run technology
Correct EFM encoding of regular bit patterns
- = Drive writes regular bit patterns
correctly
- - = Drive does not write regular bit patterns correctly
Best Read Mode:
- RAW+96 = 2352 bytes RAW Data + 96 Bytes P-W
Subchannel Data. This is the best mode for CloneCD. Reads all subchannel
information like ISRC, Catalog Numbers, CD+G, CD+MIDI, Gaps, Indices,
Digital Signatures.
- RAW+16 = 2352 bytes RAW Data + 16 Bytes
P-Q
Subchannel Data. This is the second best mode for CloneCD. Reads most
subchannel information like Gaps, Indices and most Digital Signatures.
- RAW = 2352 bytes RAW Data. No Subchannel Data
can be read.
- - = Reading from this drive is not supported.