May 28, 1996

To install the software under Windows NT V3.5.1, follow the instructions
in the Install Guide for installing your software.  To install the hardware,
take a note of the following.

ScanWizard V2.30 now operates under Windows NT 3.5.1 but the Quick Panel and
some other modules still do not operate properly under Windows NT.  
This version only supports the Adaptec ASPI compliant cards.  If you are 
using the Adaptec 1502 card which was shipped with the newer Microtek scanner 
models, all you have to do is install ScanWizard and all the drivers for your 
interface card will be installed automatically.  However, if you are using 
a different model Adaptec ASPI card, you must install the EZ SCSI software 
that came with your interface card in order to be able to use the scanner.

After installing the software on your computer, you may have to use Windows
NT Setup program in the Main group to add support for the Adaptec 1502E 
card.

- Run Windows NT Setup
- Choose Add/Remove SCSI Adapter from the Options menu
- Click on Add
- Select Adaptec 151x/152x/AIC 6260/6360 from the list
- Click Install
- When asked if you want to overwrite the current drivers click Current
- Close the menus and the Setup program
- Shutdown and restart the computer

Using the Adaptec 1502 card, we have experienced problems installing on
computers equiped with the plug and play (PNP) bios when there is another PNP 
card in the computer.  To avoid conflicts, select an interrupt you will be 
using with your Adaptec 1502 card. Go to the setup program of your computer and 
in the PNP section of the setup, tell your computer to reserve this interrupt
for an ISA card.  The reason is to avoid having the bios install this 
interrupt for one of the plug and play cards in your system.  For example, if
you decide to use interrupt 11 for the Adaptec 1502 card, tell the setup that 
interrupt 11 is used for an ISA card.  Then set the 1502 card to interrupt 11
and install it in your computer.

Make sure you do not install the EZ SCSI software on Microtek CD ROM since
this software does not support Windows NT.