D-fx Flanger Parameters
The D-fx Flanger plug-in has the following parameters:
Input Level
Allows you to adjust the input volume of the flanger to prevent clipping or increase the level of the processed signal. This slider is set to a default of +3ádB. If your source audio has been recorded very close to peak level, this +3ádB default setting could cause clipping. Use this control to reduce the input level.
Mix
Allows you to adjust the balance between the Dry (source) signal and the Wet (processed) signal, giving you control over the depth of the effect.
High Pass Filter
Controls the cutoff frequency of the High Pass Filter, allowing you to attenuate the frequency content of the feedback signal and the frequency response of the flanging. The higher the setting, the more low frequencies are removed from the feedback signal.
LFO Rate
Allows you to adjust the rate of the low frequency oscillator (LFO) applied to the delayed signal as modulation. The higher the setting, the more rapid the modulation. Use the LFO Waveform selector to select either a sine wave or a triangle wave as a modulation source.
LFO Width
Allows you to adjust the intensity of the LFO applied to the delayed signal as modulation. The higher the setting, the more intense the modulation.
Feedback
Controls the amount of feedback applied from the output of the delayed signal back into its input. Negative settings provide a more intense effect.
