CPU Heat Tab

By Default this Tab is turned off and should not be used by a Novice.

The idea and request for this tab came from Martin Goldmann at www.acdc.dk

The idea behind it is that when you cool to very low temperatures you might want to avoid a too low temperature to prevent condensation, with this tab you can make MBM start a thread to keep the CPU active and thus make it heat up. You can also set the temperature on which to stop this thread.

YOU USE THIS AT YOUR OWN RISK

Settings

Activate on Sensors

default := Unchecked
With this checkbox you enable or disable the CPUHeat code, below it you find your 3 sensors and you can select on which sensor the CPUHeat code should respond. It is wise to only check your CPU sensor and NOT your case

Listbox:

default :=CPUHeatUp
In this box you can select what piece of code to run, CPUHeat Up or a 3rd party piece (if it comes avaible)

Start when any selected sensor reaches x or lower

default := -3░C / 26░F
Here you set the value on which CPUHeatUp or a 3rd party piece will be executed. Please understand that this will happen if ANY of the SELECTED sensors reaches this value

Stop when all selected sensor reaches x or higher

default := 5░C / 41░F
Here you set the value on which CPUHeatUp or a 3rd party piece will be terminated. Please understand that this will ONLY happen if ALL of the SELECTED sensors reach this value.