Follow these simple steps to configure
your Lucent CellPipe for eMule. This setup assumes you
have a PPPOE connection like DSL running.
|
| Start a telnet session with your routers
IP. To do so |
| |
a) Use the Windows Hyper
Terminal and type in a Name
(does not matter which) for the new session,
choose TCP/IP (Winsock) as connection type
then enter your router's IP as the host address |
| |
or |
| |
b) Go to Start -> Run -> telnet
router's IP |
| In the telent sessions that starts enter
these commands each on a single line: |
| |
pat addpatin pppoe 4662/tcp client's
IP
pat addpatin pppoe 4672/udp client's
IP
save |
| |
|
| Router's IP is the IP address
of your CellPipe router and client's IP is
the IP address of your computer running eMule. |