WAVE EDITOR

Pop-Up Menu

This page covers the commands available on the wave editor's right-click menu.

Toggle Edit/HZoom

Switches to zoom mode.

Cut

Moves the selection to the clipboards

Copy

Copies the selection to the clipboard.

Paste

• Paste Over - Replaces the selection witht he clipboard contents (if the selection is shorter, only part of the clipboard contents are used).
• Paste Insert - Insert the clipboard contents at the start of the current selection.

Goto

• Loop Start - Scrolls the view (if necessary) to the loop start position.
• Loop End - Scrolls the view (if necessary) to the loop start position.
• Selection Start - Scrolls the view (if necessary) to the loop start position.
• Selection Start - Scrolls the view (if necessary) to the loop start position.

Selection

• Select All - Selects the entire wave.
• Select Loop - Selects the loop area.
• Selection = Left - Selects only the left channel.
• Selection = Right - Selects only the right channel.
• Selection = Both - Selects both channels.

Scroll

• Scroll Left - Scroll the view to the left.
• Scroll Right - Scroll the view to the right.

Zoom

• Selection - Zooms to the current selection.
• In Vertically - Zooms in vertically.
• Out Vertically - Zooms out vertically.
• In Horizontal Maximum - Zooms in vertically to the maximum zoom level allowed.
• Out Horizontal Overview - Zoom out vertically to see the entire span of the wave.
• In Vertically - Zooms in vertically.
• Out Vertically - Zooms out vertically.
• In Horizontal Maximum - Zooms in vertically to the maximum zoom level allowed.
• Out Horizontal Overview - Zoom out vertically to see the entire span of the wave.

File

• Open - Click this button to open a sample for editing.
• Save - Saves the changes to the edited sample.

Play

• Play Selection - Plays only the part of the wave you have selected.
• Play Loop - Play the loop determined by the loop points of the wave (if any).
• Play All - Plays the entire sample.
• Play Selection Unlooped - Plays only the part of the wave you have selected without looping.

Process

Contains the following set of commands to process the wave (most commands require selection to operate properly):

• Fade In - Applies a fade in effect to the selection.
• Fade Out - Applies a fade out effects to the selection.
• Normalize - Increases the overall sample volume as much as posisbel before clipping occurs.
• Reverse - Reverses the direction of the selected part of the wave.
• Invert - Inverts the polarity of the selected part of the wave.
• Stereo <-> Mono - Toggles the wave betwene mono and stereo format. NOTE: When converting from stereo to mono, all stereo data will be lost and can not be restored by switching later back to stereo.
• Swap Channels - Swaps the left and right channels in a stereo sample.
• DC Removal - Centers the wave if it has DC offset.
• Crossfade Loop - Crossfades the looped section of the sample (not selection!) to fix any occuring clicks and pops at the loop points.

Settings

Opens the wave editor's Settings window.

About

Brings a dialog containing information about the wave editor product.