C2014   LOOP statement violates enclosing SEQUENCE

     Explanation:  You specified a LOOP statement within BEGIN SEQUENCE
     and RECOVER statements without an enclosing DO WHILE or FOR loop.  This
     could happen for several reasons:

     1. You specified a LOOP statement with no enclosing DO WHILE or FOR
        control structure within a SEQUENCE.

     2. You are attempting to LOOP to a DO WHILE or FOR statement outside the
        current SEQUENCE from within the SEQUENCE.

     Action:

     1. Check to determine if you omitted the DO WHILE or FOR control
        structure statements.  If so, add the control structure statements.

     2. Check to determine if you intended to LOOP to a control structure
        enclosing the current SEQUENCE.  If so, you must BREAK to the RECOVER
        or the END statements and then LOOP.