H3000/5000/7000 Spezifikationen

H-Series Endstufen Spezifikationen

MODEL H7000 H5000 H3000

POWER OUTPUT LEVEL
f=20Hz - 20kHz, THD+N 0.1% or less
STEREO RL=8 ohms
STEREO RL=4 ohms
MONO RL=8 ohms

750W + 750W
950W + 950W
1900W

550W + 550W
700W + 700W
1400W

350W + 350W
450W + 450W
900W

FREQUENCY RESPONSE f=10Hz-50kHz, 0dB +0 / -1dB (RL=8 ohms, Po=1W)

POWER BAND-WIDTH 10Hz-50kHz, Half Power, THD+N=0.1%

TOTAL HARMONIC DISTORTION (THD+N)
f=20Hz - 20kHz, Half Power
STEREO RL=8 ohms, 4 ohms
BRIDGE RL=8 ohms

0.05% or less
0.05% or less

0.05% or less
0.05% or less

0.07% or less
0.07% or less

INTERMODULATION DISTORTION
Half Power, f=60Hz: 7kHz, 4:1
STEREO RL=8 ohms, 4 ohms
BRIDGE RL=8 ohms

0.05% or less

0.05% or less

0.07% or less

CHANNEL SEPARATION
Half Power, RL=8 ohms
ATT. max. Input 600 ohms shunt 60dB or more, f=20Hz - 20kHz
80dB, 1kHz

RESIDUAL NOISE
12.7kHz LPF
IHF - A network -70dB or less ; ATT min.
-80dB or less; ATT min.

SIGNAL-TO-NOIZE RATIO
INPUT 600 ohms SHUNT
12.7kHz LPF
IHF - A network
105dB or more
110dB
103dB or more
108dB
101dB or more
106dB

DAMPING FACTOR more than 200
(1kHz, 8 ohms)

SLEW RATE
STEREO
MONO
+/-30V / microsec (8 ohms, Full Swing)
+/-50V / microsec (8 ohms, Full Swing)

SENSITIVITY +8dB (8 ohms, 750W, ATT=max.) +6dB (8 ohms, 550W, ATT=max.) +4dB (8 ohms, 350W, ATT=max.)

VOLTAGE GAIN
ATT=max., 32dB

INPUT IMPEDANCE 30k ohms (balanced), 15k ohms (unbalanced)

INDICATORS POWER (STAND-BY) : Red
TEMP; Heatsink Temp
(85 degrees centigrade [185 degrees Fahrenheit] or more); Red (flashing)
PROTECTION (NUTE) : Red
COMP/LIMIT: (Red)
OUTPUT SIGNAL x 2 : Yellow
INPUT SIGNAL x 2 : Green

PROTECTION Power SW ON/OFF muting
Heatsink temp ; 95 degrees centigrade [203 degrees Fahrenheit] or more

PC LIMITER RL; 1 ohm or less

LIMITER CIRCUIT Comp; THD 0.5% or more (f=1kHz)

FAN CIRCUIT FAN SPEED : POWER ON
50deg. C. or less (heat sink temp.) - Low-speed
50-70deg. C. (heat sink temp.) - variable
70deg. C. or more(heat sink temp.) - High-speed

CONTROLS FRONT : POWER SWITCH (Push ON / Push OFF)
INPUT ATTENUATOR (31-Position dB calibrated)
REAR : MODE SWITCH (STEREO / BRIDGE / PARALLEL)
PIN-1 GND SW; ON/OFF

POWER REQUIREMENTS & CONSUMPTION
General Models 120V, 60Hz, 600W (900VA)
230V, 50 / 60Hz, 600W 120V, 60Hz, 500W (700VA)
230V, 50 / 60Hz, 750W 120V, 60Hz, 400W (500VA)
230V, 50 / 60Hz, 400W

DIMENSIONS (W x H x D) 480mm x 100.5mm x 455.8mm
Panel height: 88mm
Depth behind front panel: 407mm

WEIGHT 26.5 kg 24 kg 26 kg

CONNECTORS
INPUT

XLR-3-31 type x2
XLR-3-32 type x 2
1/4" Phone (balanced) x 2
5-way binding posts x 2

MODEL	H7000	H5000	H3000
POWER OUTPUT LEVEL f=20Hz - 20kHz, THD+N 0.1% or less STEREO RL=8 ohms STEREO RL=4 ohms MONO RL=8 ohms	750W + 750W 950W + 950W 1900W	550W + 550W 700W + 700W 1400W	350W + 350W 450W + 450W 900W
FREQUENCY RESPONSE	f=10Hz-50kHz, 0dB +0 / -1dB (RL=8 ohms, Po=1W)
POWER BAND-WIDTH	10Hz-50kHz, Half Power, THD+N=0.1%
TOTAL HARMONIC DISTORTION (THD+N) f=20Hz - 20kHz, Half Power STEREO RL=8 ohms, 4 ohms BRIDGE RL=8 ohms	0.05% or less 0.05% or less	0.05% or less 0.05% or less	0.07% or less 0.07% or less
INTERMODULATION DISTORTION Half Power, f=60Hz: 7kHz, 4:1 STEREO RL=8 ohms, 4 ohms BRIDGE RL=8 ohms	0.05% or less	0.05% or less	0.07% or less
CHANNEL SEPARATION Half Power, RL=8 ohms ATT. max. Input 600 ohms shunt	60dB or more, f=20Hz - 20kHz 80dB, 1kHz
RESIDUAL NOISE 12.7kHz LPF IHF - A network	-70dB or less ; ATT min. -80dB or less; ATT min.
SIGNAL-TO-NOIZE RATIO INPUT 600 ohms SHUNT 12.7kHz LPF IHF - A network	105dB or more 110dB	103dB or more 108dB	101dB or more 106dB
DAMPING FACTOR	more than 200 (1kHz, 8 ohms)
SLEW RATE STEREO MONO	+/-30V / microsec (8 ohms, Full Swing) +/-50V / microsec (8 ohms, Full Swing)
SENSITIVITY	+8dB (8 ohms, 750W, ATT=max.)	+6dB (8 ohms, 550W, ATT=max.)	+4dB (8 ohms, 350W, ATT=max.)
VOLTAGE GAIN ATT=max.,	32dB
INPUT IMPEDANCE	30k ohms (balanced), 15k ohms (unbalanced)
INDICATORS	POWER (STAND-BY) : Red TEMP; Heatsink Temp (85 degrees centigrade [185 degrees Fahrenheit] or more); Red (flashing) PROTECTION (NUTE) : Red COMP/LIMIT: (Red) OUTPUT SIGNAL x 2 : Yellow INPUT SIGNAL x 2 : Green
PROTECTION	Power SW ON/OFF muting Heatsink temp ; 95 degrees centigrade [203 degrees Fahrenheit] or more
PC LIMITER	RL; 1 ohm or less
LIMITER CIRCUIT	Comp; THD 0.5% or more (f=1kHz)
FAN CIRCUIT	FAN SPEED : POWER ON 50deg. C. or less (heat sink temp.) - Low-speed 50-70deg. C. (heat sink temp.) - variable 70deg. C. or more(heat sink temp.) - High-speed
CONTROLS	FRONT : POWER SWITCH (Push ON / Push OFF) INPUT ATTENUATOR (31-Position dB calibrated) REAR : MODE SWITCH (STEREO / BRIDGE / PARALLEL) PIN-1 GND SW; ON/OFF
POWER REQUIREMENTS & CONSUMPTION General Models	120V, 60Hz, 600W (900VA) 230V, 50 / 60Hz, 600W	120V, 60Hz, 500W (700VA) 230V, 50 / 60Hz, 750W	120V, 60Hz, 400W (500VA) 230V, 50 / 60Hz, 400W
DIMENSIONS (W x H x D)	480mm x 100.5mm x 455.8mm Panel height: 88mm Depth behind front panel: 407mm
WEIGHT	26.5 kg	24 kg	26 kg
CONNECTORS INPUT	XLR-3-31 type x2 XLR-3-32 type x 2 1/4" Phone (balanced) x 2 5-way binding posts x 2

*Dynamic Power:f=1kHz, 20ms, RL=2 ohms, STEREO
H7000 2000W
H5000 1500W
H3000 1000W

0dB = 0.775V, Half Power= 1/2 Power Output Level (Rated Power)
(Alle Angaben ohne Gewähr.)