QSG.htmTEXTMSIE���N��N��颱 Install Driver and Setup PPP for MacOS

Install Driver and Setup PPP for MacOS

This section provides step by step procedures to install the USB device driver and setup PPP on MacOS.

Install Driver for MacOS

Omni56K_Plus_USB_Installer, a MindVision VISE Installer, is used to install ZyXEL Omni56K Plus USB device driver on your Macintosh. Follow the instructions below to install the USB device driver on your Macintosh.

  1. Be sure your Omni56K Plus is powered on.
  2. Insert the CD attached with your modem device into your CD-ROM drive. You will see the icon as shown below:

  3. Plug the USB connector connecting to the Omni56K Plus into any one of your devices with USB port, such as your computer, monitor and keyboard, etc..
  4. Double click on the Omni56K_Plus_USB_Installer icon. Then, click Continue.
  5. Click on Install button. The ZyXEL USB device driver will be installed in the extension folder of the system folder.

  6. This installation requires your computer to restart after installing the USB device driver. Now, click on Continue.

  7. Click on Restart to reboot your Macintosh.

At this moment, you have finished the USB device driver installation for your MacOS. Following is the information to setup PPP connection for Internet access.

Setup OT/PPP for MacOS

Before using OT/PPP, you must use control panels to setup Modem, TCP/IP and Remote Access(or PPP).

Setup the Modem Control Panel

  1. Choose Control Panels from Apple Menu and open the Modem control panel. You will see a window as shown below:
  2. Choose the port to ZyXEL Omni56K Plus from the “Connect via” pop-up menu.
  3. Choose ZyXEL Omni56K Plus from the “Modem” pop-up menu.
  4. Close and save.

Setup TCP/IP for PPP

  1. Choose Control Panels from Apple Menu and open the TCP/IP control panel. You will see a window as shown below:

  2. Choose PPP from the “Connect via” pop-up menu.
  3. Choose your configuration method from the “Configure” pop-up menu. For example, Using PPP Server.
  4. The most common selection is Using PPP Server which causes OT/PPP to request IP address from the server when it connects.
  5. Enter name server addresses.
  6. Close and save.

Setup Remote Access(or PPP)

  1. Choose Control Panels from Apple Menu and open the Remote Access(or PPP) control panel. You will see a window as shown below:

  2. Click Setup to show this panel’s screen.
  3. Click Guest or Registered User.
  4. Enter your PPP user name and password in the text boxes.
  5. Enter your ISP's telephone number in the Number text box.

Click Connect. This will start to dial up and make an OT/PPP connection.

x�䕸FEJ�寵PT�>DF湋漌D�4dD�QSG.htmgiff6K Plus QSGtaller ).鬞EXTMSIE��#q��f`蚌@e"02jUD`逆Fx�𤒈d;VJ D� #F@Tf fgǘFd�dTdK�,覡UMC甦fy�偗�:陜九"02f僙e3圩i轧Fe>FED�#FDDfS0dfwvF@0FDDfK+dDFE鋁fww剭���